Photosmart D7360 error message 0xc18a0201 ink system failure.

Solutions

It doesn't work like that with turn on the printer and etc..., etc..., you have to disassemble the printer of the sides to the write head after that u have to do 2 steps:
1. The green wire from the left side grab outside then turn on the printer immediately turn off. Put the green wire bag on it's place.
2. On the right side on the motherboard u will found 2 white cable very thin, grab outside and turn on the printer, immediately turn off. put the 2 cable back on it's places and turn on again the printer. Now it should work.

Hi I found this I know your error not in here but it may work for It worth a try nothing to lose and it may work. I know your error code is not in this but it some times it clean the error with this type of error number you can gave it a go try not harm it Error code: 0xc18a0201, 0xc18a0206, 0xc18a0306, 0xc18a030a, 0xd0620130, 0x887dd03a, 0xd05d010d, 0xf0af8004, 0xc19ac3ff, 0xc18a050...
Reset the product:
1. Without turning off the product, disconnect the USB cable from the rear of the product.
2. Remove the cartridges from the product.
3. Wait for the 'Insert Cartridges ' message to display on the control panel.
4. Disconnect the power cord from the back of the product.
5. Wait 60 seconds.
6. Reconnect the power cord. If the product does not automatically turn on, press the Power button ( ).
7. Reinsert the cartridges, and then close any open doors on the product.
8. If you receive a prompt to print a calibration page, do so.
9. Reconnect the USB cable to the rear of the product, and then try printing again.
Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.